DIY Skull Bracelet

10.29.13

Skull-Bracelet

I wanted to make something in honor of the upcoming holiday. I found these cute little skull beads at Michaels and decided they would make the perfect bracelet. It is dainty and punk rock all at the same time. While I won’t be dressing up for Halloween this year, this bracelet will definitely keep me in the spooky spirit!

Skull-Bracelet

Materials

– Skull Beads
– Chain
– Wire
– Ruler
– Wire Cutter
– Pliers
– Jump Rings & Fasteners

Skull-Bracelet
1. Cut a piece of wire to about 3″. This is longer than you need but it’s good to leave room for error. Using the pliers, make a small loop on one end of the wire. Make sure the skull bead doesn’t pass through. Loop the opposite side to hold the bead in place.

Skull-Bracelet
2. Measure the chain to cut two separate pieces approximately 3″ in length.

Skull-Bracelet
3. Attach on piece of chain to one end of the wire loops you just made on the bead. Attach the second chain to the opposite side.

Skull-Bracelet
4. Attach one jump ring on the end of one chain. Attach a jump ring and fastener to the second chain.

Skull-Bracelet
5. And you’re done! Enjoy your skull bracelet!!